Soil Moisture sensor with Arduino in Tinkercad | how to use soil moisture sensor in Tinkercad Circuit diagram: Arduino Sketch: // C++ code // int moisture_data = 0; void setup() { pinMode(A0, INPUT); Serial.begin(9600); pinMode(12, OUTPUT); pinMode(6, OUTPUT); } void loop() { moisture_data = analogRead(A0); Serial.println(moisture_data); if (moisture_data < 21) { digitalWrite(12, HIGH); digitalWrite(6, HIGH); } else { digitalWrite(12, LOW); digitalWrite(6, LOW); } delay(10); // Delay a little bit to improve simulation performance }
Soil Moisture sensor with Arduino in Tinkercad | how to use soil moisture sensor in Tinkercad
Circuit diagram:
.png)
Arduino Sketch:
// C++ code
//
int moisture_data = 0;
void setup()
{
pinMode(A0, INPUT);
Serial.begin(9600);
pinMode(12, OUTPUT);
pinMode(6, OUTPUT);
}
void loop()
{
moisture_data = analogRead(A0);
Serial.println(moisture_data);
if (moisture_data < 21) {
digitalWrite(12, HIGH);
digitalWrite(6, HIGH);
} else {
digitalWrite(12, LOW);
digitalWrite(6, LOW);
}
delay(10); // Delay a little bit to improve simulation performance
}
hello..
ReplyDeletewhat is the coding if i want to use relay instead of the led... is it the same block code??